Description

Core drill with Morse taper shank Design: HSS, DIN 343, type N. Profile grinding, steam tempered surface, right cutting. Normal angle of rake, normal core thickness and without core gradient. Application: For drilling out pre-drilled, pre-cast or pre-punched holes. The sturdy construction and 3 blades means that alignment inaccuracies and runouts in pre-drilled holes are corrected. In addition, the drill wall surface is so far improved that can then be thoroughly finished with a reamer. Please pay attention to the column "smallest Ø of pre-drilled hole". Note: The cut diameter must be smaller than the hole to be drilled out. Further dimensions or HSS-E versions or solid carbide/carbide components or long core drills according to DIN 1864 available on request.

Specifications

Schneidstoff	HSS
Stähle bis 1000 N/mm²	25
Stähle bis 1400 N/mm²	10
Spirallänge	140 mm
Stähle bis 850 N/mm²	30
Typ	TYP N
Durchmesser	20,00 mm
Ø h8	20,00 mm
Al, Al- und Mg-Leg.	45
MK	2
Gesamtlänge	238 mm
kleinster Ø des vorgebohrten Loches	14,0 mm